The video demonstrates how to fully assemble the A-trex 3DFit Scanner, from unpacking each component to securing the base plate, attaching the tower, installing the scanner module, and positioning the calibration panel. It walks through every essential assembly step to ensure the scanner is stable, aligned, and ready to be connected to the iPad for use.

Steps
• Remove all scanner components from the box and place them on a flat, clean surface.
• Locate the scanner base plate and position it with the front label facing forward.
• Attach the base plate to the vertical stand using the designated screws.
• Insert the main scanner tower into the stand and tighten it securely.
• Slide the scanner head module onto the tower until it locks into place.
• Attach the cable guide and route the cables through the tower as instructed.
• Connect the scanner cables to the correct ports on the back of the scanner head.
• Place the calibration panel in the front bracket of the scanner stand.
• Ensure all screws, brackets, and connections are tight and properly aligned.
• Prepare to pair and connect the scanner to the iPad (as referenced in the connection tutorial).